Steps to oiling a paper shredder start by checking the oiling needs of the gadget, using the appropriate type of oil, putting the right amount of oil, and distributing the oil.
Paper shredder gadgets are considerably becoming popular in households and business offices because of the protection they provide from identity thieves. However, much like any other device, these machines need routine maintenance to continuously and effectively serve its function, such as oiling. Fortunately, oiling these machines is very easy to do. Just read this article to learn how.
Check the oiling needs of the gadget
Depending on the level of security your paper shredder can provide, the more secure it is, the more it needs to be oiled. So, in other words, strip-cut paper shredders need the least oiling, and those units used in high protection locations need the most. This is because the tinier the pieces of paper are cut, the more dust is generated, which in time accumulates on the cutting blades. Strip-cut paper shredders cut less paper as compared to its higher end counterparts, and thus generate only less dust every time the gadget is utilized. Dust also naturally accumulates over time and when the unit is often used. Most manufacturers would advise oiling your unit every 30 minutes while being utilized to an hour. A very good tip would be to oil the shredder about three to four times each week if you seldom use it, and to adhere to the instructions of the manufacturer if the unit is often used.
Use the right type of oil
According to paper shredding phoenix, it is important to use the correct type of oil, one that is intended specifically for your unit and recommended by its manufacturer. You can not just utilize any type of oil because the oil meant for these units are needed to be heat tolerant and must also have been calibrated especially for these units.
Apply the correct amount of oil
Apply oil onto the blades, from one end to the other, at the cutter opening for approximately 2 seconds. This should be long enough for the correct amount of oil to lubricate the cutting blades, because applying too fast might result in an insufficient amount of oil, and too slow may also result in excessive oil on the blades of the shredder. Paper shredder lubricating oils also come in various forms of containers. Thus, depending on its bottle, pour, squirt, or spray the oil onto the blades of the unit.
Spread the oil
Distribute the oil you applied onto the cutters of the shredder by turning the machine on the manual mode and pressing the “Reverse” button. Let the cutters run this direction for a couple of seconds, then press the “Standard” or “Forward” button. Let it run in this track too for a couple moments. Running the unit in both ways will enable the oil to be distributed through the entire shredder unit. After you’ve placed oil directly onto the blades, you may also shred a piece of paper with oil to be sure that oil gets to all sections of the cutting blades. To do this, just apply or spray a piece of paper with oil in a zigzag pattern. The zigzag pattern is important to make sure that oil does not quickly get saturated into the paper before any of it can get to the cutting blades. You can also feed the machine another oiled piece of paper to be sure that the blades are now well lubricated.
It is essential that you use the oil suggested by the manufacturer of the unit so as not to nullify its warranty. In addition, if your unit has not been functioning properly, it is advisable to bring this to its service center instead of trying to fix it on your own.